Edge FWD V6-3.5L (2007)
2. Position aside the quarter trim panel.
-
Pull out on the quarter trim panel at the C-pillar to release the retaining clip to access the safety belt retractor.
3. NOTE: Inspect the rear safety belt retractor D-ring cover for damage. If the rear safety belt retractor D-ring cover does not remain in place, install
a new cover.
Remove the rear safety belt retractor D-ring cover.
4. Remove the bolt and rear safety belt retractor D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Remove the bolt and rear safety belt retractor.
-
Lift up to release the locator T-tab from the C-pillar sheet metal.
-
To install, tighten to 40 Nm (30 lb-ft).
6. To install, reverse the removal procedure.
7. Check the active restraint system for correct operation.