Edge FWD V6-3.5L (2007)
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could
result in pretensioner or air bag deployment and could result in serious personal injury.
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
All seats
1. Depower the SRS.
2. Position the seat all the way up and back.
3. NOTE: Note the position of the safety belt buckle pretensioner anti-rotation locator tab for installation.
From the rear of the seat, remove the safety belt buckle pretensioner nut.
-
Vehicles with a manual driver seat, remove the safety belt buckle pretensioner bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Position the safety belt buckle pretensioner towards the front of the vehicle to access the electrical connectors.
Seats with power
5. Remove the safety belt buckle pretensioner cover.
All seats
6. Remove the safety belt buckle pretensioner.
1. Disconnect the safety belt buckle pretensioner buckle switch electrical connector.
2. Disconnect the safety belt buckle pretensioner electrical connector.
3. Cut the tie strap and remove the safety belt buckle pretensioner.
7. To install, reverse the removal procedures.
8. Repower the SRS.
9. Check the active restraint system for correct operation.
