Edge FWD V6-3.5L (2007)
2. Depower the system.
3. Remove the front door scuff plate.
-
Pull up to release the 5 retaining clips.
4. Remove the rear door scuff plate.
-
Pull up to release the 2 retaining clips.
5. Detach the 2 retainers and remove the lower B-Pillar trim panel.
6. Disconnect the side impact sensor electrical connector.
7. WARNING: The tightening torque of the air bag side impact sensor retaining bolt is critical for correct system operation. Failure to
follow tightening instruction may result in serious personal injury.
NOTE:
-
Make sure the B-pillar and side impact sensor mating surfaces are clean and free of foreign material.
-
Note the position of the side impact sensor locating tabs for installation.
Remove the bolt and the side impact sensor.
-
To install, tighten to 11 Nm (8 lb-ft).
8. To install, reverse the removal procedure.
9. Repower the system.