Edge FWD V6-3.5L (2007)
3. Position aside the quarter trim panel.
-
Pull out on the quarter trim panel at the C-pillar to release the retaining clip to access the C-pillar side impact sensor.
4. Disconnect the side impact sensor electrical connector.
5. WARNING: The tightening torque of the air bag side impact sensor retaining bolt is critical for correct system operation. Failure to
follow tightening instructions may result in serious personal injury.
NOTE:
-
Note the position of the 2 side impact sensor locating tabs for installation.
-
Make sure the C-pillar and side impact sensor mating surfaces are clean and free of foreign material.
Remove the bolt and the side impact sensor.
-
To install, tighten to 11 Nm (8 lb-ft).
6. To install, reverse the removal procedure.
7. Repower the system.