Edge FWD V6-3.5L (2007)
8. Install the 2 rear cross brace screws.
-
Tighten to 5 Nm (44 lb-in).
9. Install the 2 front cross brace screws.
-
Tighten to 5 Nm (44 lb-in).
Inboard OCS weight sensor bolt(s)
10. Install the nut and the safety belt buckle pretensioner.
-
Tighten to 40 Nm (30 lb-ft).
All OCS weight sensor bolt(s)
11. Install the manual seat track.
12. Install the passenger seat and repower the supplemental restraints system (SRS). Do not prove out the SRS at this time.
13. Carry out the appropriate procedure after installation of an OCS system component.
-
If installing the original OCS system component, carry out the Zero Seat Weight Test and prove out the SRS. See: Air Bag Systems/Testing
and Inspection/Component Tests and General Diagnostics
-
If installing a new OCS system component, carry out the System Reset procedure and prove out the SRS. See: Air Bag Systems/Service and
Repair/Occupant Classification Sensor (OCS) System Reset
