Edge FWD V6-3.5L (2007)
10. CAUTION: Place absorbant pads in the general work area in case of fuel spillage.
Release the lock tab, rotate the fuel level sensor counterclockwise approximately 1/4 turn and lift upward.
11. CAUTION:
-
The fuel level sensor must be handled carefully to avoid damage to the float arm.
-
Carefully remove the fuel level sensor from the fuel tank to avoid fuel spillage inside the vehicle.
Carefully lift and remove the fuel level sensor from the fuel tank.
12. CAUTION: Inspect the mating surfaces of the fuel level sensor flange and the fuel tank O-ring seal contact surfaces. Do not polish or
adjust the O-ring seal contact area of the fuel tank flange or the fuel tank. Install a new fuel level sensor or fuel tank if the O-ring seal
contact area is bent, scratched or corroded.
NOTE:
-
To install, apply clean engine oil to the O-ring seal.
-
Upon installation, properly seat and press down firmly on the fuel level sensor, rotate it clockwise until the lock arrow on the sensor aligns
with the notch on the tank. Torque should not exceed 15 Nm (11 lb-ft).
To install, reverse the removal procedure.
