Edge FWD V6-3.5L (2007)
Installation
All OCS weight sensor bolt(s)
1. CAUTION: Do not overtighten the side plate with the occupant classification sensor (OCS) weight sensor bolts to the bench or table.
Tighten only enough to compress the spring washer. Overtightening may damage the side plate or OCS weight sensor bolts.
Position the spring washer and OCS weight sensor bolt in the side plate. Then clamp the side plate to a bench or table to compress the OCS weight
sensor bolt spring washer.
2. NOTE: Make sure the occupant classification sensor (OCS) weight sensor bolt retaining clip is seated fully in the OCS weight sensor bolt groove
underneath the OCS weight sensor O-ring seal.
Install the 2 new OCS weight sensor bolt retaining clips in the OCS weight sensor groove underneath the O-ring seal.
3. Unclamp the side plate with the installed OCS weight sensor bolt from the bench or table.
