Edge FWD V6-3.5L (2007)
Alignment: Service and Repair
Camber Adjustment - Front
Camber Adjustment - Front
NOTE: Front camber is adjusted through the use of the upper strut plate. Rotating the upper strut plate 180 degrees will change the camber +0.5
degrees.
1. Using alignment equipment and the manufacturer's instructions, measure the camber.
2. Remove the 4 strut upper mounting plate nuts.
^
To install, tighten to 30 Nm (22 ft. lbs).
3. Using a suitable jack, raise the vehicle body enough to allow the front strut upper plate mounting studs to clear the frame.
4. NOTE: Rotating the upper strut plate 180 degrees will change the camber +0.5 degrees.
Rotate the upper mounting plate 180 degrees.
5. Recheck the front camber settings.
6. Check and, if necessary, adjust the front toe.