Edge FWD V6-3.5L (2007)
Stabilizer Link: Service and Repair
Rear
Stabilizer Bar and Link
Stabilizer Bar and Link
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in
major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement
part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these
parts.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove and discard the stabilizer bar link upper nuts.
^
To install, tighten to 35 Nm (26 ft. lbs).
3. Remove and discard the stabilizer bar link lower nuts and remove the stabilizer bar links.
^
To install, tighten to 35 Nm (26 ft. lbs).
4. Remove and discard the stabilizer bar bracket nuts and remove the stabilizer bar brackets and the stabilizer bar.
^
To install, tighten to 55 Nm (41 ft. lbs).