Edge FWD V6-3.5L (2007)
4. Remove the muffler and tailpipe assembly.
5. Disconnect the LH and RH wheel speed sensor connectors.
6. NOTE: All wheel drive (AWD) shown, front wheel drive (FWD) similar.
Remove the connector from the front of the subframe and position aside.
7. CAUTION: Do not allow the brake caliper and anchor plate assembly to hang from the brake hose or damage to the hose may occur.
Remove the 4 bolts (2 each side) from the rear hub spindle-to-brake caliper.
-
To install, tighten to 70 Nm (52 lb-ft).