Edge FWD V6-3.5L (2007)
Spring (Part 2)
Removal and Installation
All vehicles
CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in
major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement
part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these
parts.
CAUTION: Suspension bushing fasteners must be tightened with the weight of the vehicle resting on the wheel and tires.
1. Remove the wheel and tire assembly.
2. CAUTION: Do not allow the brake caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the 2 anchor plate bolts and position the brake caliper and anchor plate assembly aside.
^
Support the brake caliper and anchor plate assembly using mechanic's wire.
^
To install, tighten to 55 Nm (41 ft. lbs).
3. Remove the brake disc.
4. Remove the nut and disconnect the stabilizer bar link and parking brake cable bracket from the wheel knuckle.
^
Discard the nut.
^
To install, tighten to 35 Nm (26 ft. lbs).
5. Remove the bolt, unclip the 2 retainers from the upper arm and position aside the wheel speed sensor.
^
To install, tighten to 7 Nm (62 inch lbs).
6. Remove the brake hose bracket bolt and position the hose aside.
^
To install, tighten to 7 Nm (62 inch lbs).
