Edge FWD V6-3.5L (2007)
CAUTION: Make sure that the filter passage areas are clean of foreign material before installing the filter. Damage to the transaxle will
occur if the filter passages are not clean.
Install a new solenoid body filter assembly by pushing it straight down on to the alignment tabs.
6. CAUTION: Make sure not to pinch the TSS, OSS or TR sensor wiring harnesses when installing the solenoid body. Damage to the wiring
harness will occur.
NOTE: Install the different length bolts in the locations noted during disassembly.
Install the solenoid body and the 11 bolts.
1
42 mm (1.65 inch) bolt
2
63 mm (2.48 inch) bolts
3
80 mm (3.14 inch) bolts
4
95 mm (3.74 inch) bolts
7. Tighten the solenoid body bolts in the sequence shown.
^
Tighten to 12 Nm (9 ft. lbs).