Edge FWD V6-3.5L (2007)
23. Remove the bolt and the OSS sensor.
Installation
1. Install the OSS sensor and the bolt.
^
Tighten to 12 Nm (9 ft. lbs).
2. NOTE: Make sure that the manual lever pin (part of the TR sensor) is correctly installed in the manual valve.
Position the TSS, OSS and TR sensor wiring harnesses aside and install the main control valve body, the TR sensor detent spring and the 10 bolts.
Tighten the bolts in the sequence shown.
^
Tighten to 12 Nm (9 ft. lbs).
