Edge FWD V6-3.5L (2007)
3. Remove and discard the 4 universal joint flange bolts and remove the front driveshaft.
^
To install, tighten to 70 Nm (52 ft. lbs).
4. CAUTION: Do not reuse the bolts for the rear U-joint flange. Install new bolts.
Remove and discard the 4 universal joint flange bolts.
^
To install, tighten to 70 Nm (52 ft. lbs).
5. With the help of an assistant, remove the 4 center bearing support nuts and the driveshaft.
^
To install, tighten to 40 Nm (30 ft. lbs).
6. NOTE: If a driveshaft is installed and driveshaft vibration is encountered after installation, index the driveshaft.
To install, reverse the removal procedure.