Edge FWD V6-3.5L (2007)
2
Remove and discard the boot.
8. If necessary, press the anti-lock brake sensor indicator ring from the outer CV joint.
Assembly
1. NOTE: Do not mix the boot clamps.
If removed, install a new anti-lock brake sensor indicator ring on the outer CV joint.
2. Lubricate the outboard CV joint.
1
Pack the outboard CV joint with grease from the kit.
^
One-third of the grease must be installed in the joint with the remainder placed in the boot.
2
Spread the remaining grease evenly inside the boot.