Edge FWD V6-3.5L (2007)
11. Position the inboard halfshaft boot and clamps.
^
Position the boot in the housing groove.
^
Position the boot clamps.
12. Set the halfshaft assembled length to specifications.
1
Measure the entire assembly length.
2
Push in or pull out on the inner joint as necessary to adjust the halfshaft assembled length.
3
Hold the inner joint to prevent the assembled length from changing, and insert a small flat-blade screwdriver between the boot and the joint to
equalize the pressure.
13. Install the boot clamps.
^
Lever arm to the closed position and use a soft-faced hammer to close the tabs.