Front Drive Halfshaft Service and Repair for Edge FWD V6-35L
5. Position the small clamp on the interconnecting shaft before installing the boot.
6. Position the boot on the interconnecting shaft.
7. Install the inner race and the retainer snap ring.
8. Install the outer race with 8 balls.
9. Insert the assembly in the housing.
10. Install the retaining ring.
11. For the inboard CV joint, carry out the following:
1
Pack the inboard CV joint housing with 108 g (3.80 oz) of grease.
2
Spread any remaining grease evenly inside the boot and CV joint.
3
Install the inboard CV joint housing, seating the boot in the groove in the housing.
12. Set the halfshaft assembled length to specifications.
1
Measure the entire assembly length.
2
Push in or pull out on the inner joint as necessary to adjust the halfshaft assembled length.