Front Door Window Regulator Replacement for Edge FWD V6-35L (2007)
2. NOTE: Support window glass before cutting the window regulator cable.
Cut the window regulator cable.
Window operating
3. Reconnect the window control switch.
Window operating/not operating
4. Remove the access plugs and lower the window until the glass clamp bolts can be accessed through the 2 access holes. Tape the glass in position.
5. NOTE: If the window regulator cable was cut previously, support the regulator before the glass clamp bolts are loosened.
Loosen the glass clamp bolts.
-
To install, tighten to 8 Nm (71 lb-in).
6. Lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
7. If equipped, remove trim and disconnect the power mirror electrical connector.
-
Remove the wiring harness pushpins from the door.