Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
2
Install the seat track to floor bolts.
^
If equipped with power seats, connect the electrical connector.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result
in damaged components.
5. If equipped with power seats, connect the battery ground cable.
6. Position the driver seat forward.
7. Install the seat track to floor nuts.
8. If equipped with power seats, disconnect the battery ground cable and wait one minute.
Vehicles with side air bag
9. Remove the special tool from the driver seat side air bag module body harness electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
10. Connect the driver seat side air bag module electrical connector.
All vehicles
