Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
10. Fill the brake master cylinder reservoir and install the reservoir cap.
^
Use High Performance DOT 3 Brake Fluid C6AZ-19542-AB or equivalent meeting Ford specification ESA-M6C25-A, DOT 3.
Four Wheel Antilock Brake System Bleeding
Brake System Bleeding
Special Tool(s)
Anti-Lock Brakes Bleed
1. NOTE: Carrying out the System Bleed function drives trapped air from the hydraulic control unit (HCU). Subsequent bleeding removes the air
from the brake hydraulic system to the bleeder screws.
NOTE: The engine must be running to provide adequate voltage to the HCU module during the anti-lock control portion of the system bleed.
Connect the diagnostic tool.
2. Start the engine and depress the brake pedal to half of the full travel position.
3. Access FUNCTION TEST mode and press the trigger to run the SYSTEM BLEED FUNCTION.
4. Manually bleed the brake hydraulic system.
5. Repeat the procedure carrying out a total of two diagnostic tool cycles and two manual bleed cycles.
