Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
Fog/Driving Lamp Bulb: Service and Repair
REMOVAL
WARNING: THE HALOGEN FOG LAMP BULB CONTAINS GAS UNDER PRESSURE. THE BULB MAY SHATTER IF THE GLASS
ENVELOPE IS SCRATCHED OR IF THE BULB IS DROPPED. HANDLE THE BULB CAREFULLY. GRASP THE BULB ONLY BY ITS
BASE. AVOID TOUCHING THE GLASS ENVELOPE. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL
INJURY.
CAUTION: The fog lamp bulb should not be removed from the fog lamp until just before a new bulb is installed. Removing the bulb for an extended
period of time may affect fog lamp bulb performance. Contaminants may enter the fog lamp where they can settle on the lens and reflector. Never turn on
the fog lamps with the bulb removed.
1. Remove the wheel and tire.
2. Position the inner fender well aside.
1
Remove the bolts.
2
Remove the pin-type retainers.
3
Remove the screw.
4
Position the inner fender well aside.
3. Remove the lamp socket from the lamp assembly.
^
Disconnect the electrical connector.
4. Disconnect the bulb from the electrical connector.
INSTALLATION
1. To install, reverse the removal procedure.