Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
Engine Hot Or Cold Coolant Warning Indicator Lamp Illuminated (ON):
1.
If the coolant level is found to be below the COLD FILL RANGE (seam) add coolant, tighten pressure cap, verify that the warning lamp turns off
after key cycle and return to customer.
2.
If the coolant level is verified to be at the top of the COLD FILL RANGE (seam), disconnect the coolant level sensor and verify that the warning
lamp turns off. If the lamp does turn off then replace the degas bottle. If the lamp remains on with the sensor disconnected then perform
diagnostics on the circuit beyond degas bottle/low coolant sensor.
NOTE
IT TAKES APPROXIMATELY 25 SECONDS FOR THE LOW COOLANT LAMP TO TURN OFF AFTER THE SENSOR CIRCUIT IS
OPENED. (EXAMPLE: WHEN ADDING COOLANT TO A LOW BOTTLE WITH LAMP ON.)
NOTE
DO NOT REPLACE THE DEGAS BOTTLE UNLESS DIRECTED BY DIAGNOSTICS IN STEP 2.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 03-08-5
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
Disclaimer