Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
1. NOTE: Apply a light coat of petroleum jelly to the O-ring seal before installation.
Install the TSS sensor.
^
Connect the TSS electrical connector.
2. Remove the drain pan.
3. Install the splash shield.
4. Install the LH front wheel.
5. Lower the vehicle.
6. Check the transmission fluid level, add fluid as necessary using MERCON(R) V Automatic Transmission Fluid XT-5-QM or equivalent meeting
MERCON(R) V specification.
7. Start the engine and move the transaxle range selector lever through all near positions.