Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
8. CAUTION: If the clutch disc is saturated with oil, inspect the rear engine crankshaft seal for leakage. If leakage is found, install a new seal prior
to clutch disc installation.
NOTE: Use an emery cloth to remove minor imperfections in the clutch disc lining surface.
NOTE: Install a new clutch disc if any of the following conditions are present.
Inspect the clutch disc for:
^
oil or grease saturation
^
worn or loose facings
^
warpage or loose rivets at the hub
^
loose or broken torsion dampening springs
^
wear or rust on splines
9. Using the special tool, check clutch disc runout.Install a new clutch disc if not within specifications.
10. NOTE: Install a new clutch release fork if any of the following conditions are present.
Inspect the clutch release fork for:
^
cracks
^
distortion
^
excessive wear on the release bearing contact surface
Installation
1. Using the special tool, position the clutch disc on the flywheel.
2. Position the clutch pressure plate on the flywheel, install the pressure plate bolts and tighten them in sequence to specification.
