Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
2.
Wipe clean the seam between the rotary blade coupling and the differential housing. Check for fluid seepage at the seam. See Figure 1.
^
If no signs of fluid are found at the seam, perform Driveshaft Replacement only.
^
If signs of fluid are found at the seam, perform Driveshaft Replacement and Differential Reseal and Mass Damper Re-Installation.
DRIVESHAFT REPLACEMENT
CAUTION:
Do not reuse any driveshaft retaining fasteners. Install new fasteners only or damage to vehicle may occur.
1.
Position a safety stand under the driveshaft center bearing support. See Figure 2.
2.
Remove the bolts and straps securing the rear of the driveshaft to the differential yoke. Discard the bolts. See Figure 3.