Escape 2WD L4-122 2.0L DOHC VIN B Zetec SFI (2003)
5. NOTE: Whenever the brake master cylinder is removed from the brake booster, new nuts must be installed.
Remove the nuts and the brake master cylinder.
6. NOTE: Whenever installing a new brake master cylinder reservoir, install new seals. Lubricate the new seals with clean brake fluid.
Transfer the brake master cylinder reservoir if a new master cylinder is to be installed.
1
Lubricate the two O-ring seals with clean brake fluid and insert into the brake master cylinder.
2
Press the brake master cylinder reservoir into the O-ring seals until it snaps into the brake master cylinder securely.
7. To install, reverse the removal procedure.
^
Bleed the master cylinder.
^
If equipped with manual transmission, bleed the clutch master cylinder.