Escape 2WD L4-122 2.0L DOHC VIN B Zetec SFI (2003)
Parking Brake Cable: Service and Repair
Parking Brake Cable - Front
Removal and Installation
All Vehicles
1. Remove the parking brake control.
With Floor Console
2. Remove the two bolts and the floor console bracket.
Without Floor Console
3. Remove the LH front seat.
4. Remove the LH front door scuff plate.
5. Remove the LH lower A-pillar trim panel.
6. Remove the LH front safety belt.
7. Pull back carpet to gain access to the console bracket.
8. Remove the two bolts and the floor console bracket.
All Vehicles
9. Raise and support the vehicle.
10. Remove the front parking brake cable.
1
Disconnect the parking brake cable from the RH side rear parking brake cable.
2
Disconnect the front parking brake cable from the parking brake cable equalizer.
11. To install, reverse the removal procedure.