Escape 2WD L4-122 2.0L DOHC VIN B Zetec SFI (2003)
6. Install the lower LH center instrument panel finish panel.
7. Connect the battery ground cable.
8. With the restraint system diagnostic tools still installed at all deployable devices, prove out the air bag system. See: Air Bag(s) Arming and
Disarming/Service and Repair/Prove Out Procedure
9. Disconnect the battery ground cable and wait at least one minute.
10. Remove the restraint system diagnostic tool from the driver safety belt buckle pretensioner floor electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
11. Connect the driver safety belt buckle pretensioner electrical connector. Install the driver safety belt buckle pretensioner electrical connector onto
the bracket under the seat.