Escape 2WD L4-122 2.0L DOHC VIN B Zetec SFI (2003)
Fluid - A/T: Service and Repair
Transmission Fluid Drain and Refill
Transmission Fluid Drain and Refill
Material
Removal
1. Raise and support the vehicle.
2. Place a suitable container under the transaxle drain plug.
3. NOTE: If an integral problem is suspected, drain the fluid through a paper filter. A small amount of metal or friction particles may be found from
normal wear. However, if excessive metal and friction particles are present, internal service will be required.
Remove the transaxle drain plug and drain transmission fluid.
Installation
1. Install the transaxle drain plug.
^
After the fluid has been drained, clean the drain plug threads and apply a small amount of Pipe Sealant with Teflon D8AZ-19554-A or
XW7Z-19554-AA or equivalent meeting Ford specification WSK-M2G350-A2.
2. Lower the vehicle
3. Add 3.7 liters (3.9 quarts) of MERCON(R) V Automatic Transmission Fluid XT-5-QM or equivalent meeting MERCON(R) V specification.
4. Start the engine and run through all gears for a total of five minutes at idle. Turn off the engine.
5. Repeat the previous steps to help flush fluid from the torque converter.
