Escape 2WD L4-2.5L (2009)
Disconnect the front brake tube fittings from the HCU.
-
To install, tighten to 15 Nm (133 lb-in).
5. Disconnect the rear brake tube fittings from the jumper tubes.
-
To install, tighten to 15 Nm (133 lb-in).
6. Disconnect the electrical connector by rotating the protective cover.
7. Remove the 3 HCU bracket-to-frame bolts and remove the HCU.
-
To install, tighten to 20 Nm (177 lb-in).
8. To install, reverse the removal procedure.
-
Bleed the brake system.