Escape 2WD L4-2.5L (2009)
Vacuum Pump: Service and Repair
Brake Vacuum Pump
Removal and Installation
1. Remove the Motor Electronics Cooling System (MECS) coolant pump bolts and position the pump and ground strap aside.
-
To install, tighten bolts to 20 Nm (177 lb-in).
2. Disconnect the vacuum pump electrical connector and detach the harness retainer from the vacuum pump bracket.
3. Remove the vacuum pump bracket nut.
-
To install, tighten to 25 Nm (18 lb-ft).
4. Remove the 2 vacuum pump bracket bolts.
-
To install, tighten the bolts to 25 Nm (18 lb-ft).
-
Position the vacuum pump to detach the vacuum hose and remove the vacuum pump.
5. To install, reverse the removal procedure.