Escape 2WD L4-2.5L (2009)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
NOTE: Non-hybrid vehicles shown, hybrid vehicles similar.
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
NOTE: Do not swap ABS modules between vehicles, the ABS module and the Hydraulic Control Unit (HCU) are calibrated as an assembly.
All vehicles
1. Remove the HCU. For additional information, refer to Hydraulic Control Unit (HCU) - Hybrid See: Antilock Brakes / Traction Control
Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair.
Non-hybrid vehicles
