Escape 2WD L4-2.5L (2009)
4. Install the accessory drive belt idler pulley and bracket and the 2 bolts.
-
Tighten to 25 Nm (18 lb-ft).
5. Install the coolant pump pulley and bolts.
-
Tighten to 20 Nm (177 lb-in).
6. NOTE: Remove the through bolt from the Camshaft Front Oil Seal Installer.
NOTE: Lubricate the oil seal with clean engine oil.
Using the Camshaft Front Oil Seal Installer, install the crankshaft front oil seal.
7. Install the engine mount. For additional information, refer to Engine Mount See: Drive Belts, Mounts, Brackets and Accessories/Engine
Mount/Service and Repair/Removal and Replacement.
8. Install the crankshaft pulley. For additional information, refer to Crankshaft Pulley See: Cylinder Block Assembly/Harmonic Balancer -
Crankshaft Pulley/Service and Repair.
9. NOTICE: Only hand-tighten the bolt or damage to the front cover can occur.
Install a 6 mm x 18 mm bolt through the crankshaft pulley and thread it into the front cover.
10. Install the CKP sensor and the 2 bolts.
-
Do not tighten the bolts at this time.