Escape 2WD L4-2.5L (2009)
Hose/Line HVAC: Service and Repair
Compressor To Condenser Discharge Line
Compressor to Condenser Discharge Line - 2.5L
Removal and Installation
NOTE: Installation of a new receiver/drier is not required when repairing the A/C system, except when there is physical evidence of contamination from
a failed A/C compressor or damage to the receiver/drier.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Recover the refrigerant.
3. Remove the RH lower engine splash shield.
4. Remove the front bumper cover.
5. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the O-ring and gasket seals.
-
To install, tighten to 15 Nm (133 lb-in).