Escape 2WD L4-2.5L (2009)
Wiper Motor: Service and Repair
Wiper Motor - Rear Window
Wiper Motor - Rear Window
Removal and Installation
1. Remove the rear pivot arm. For additional information, refer to Wiper Pivot Arm - Rear See: Wiper Arm/Service and Repair/Wiper Pivot Arm -
Rear.
2. Remove the rear wiper motor shaft nut cover.
3. Remove the rear wiper motor shaft nut.
-
To install, manually finger-tighten the nut, then tighten to 6 Nm (53 lb-in).
4. Open the liftgate window.
5. Remove the rear wiper motor cover trim panel.
6. Remove the rear wiper motor.
1. Disconnect the electrical connector.
2. Remove the 2 rear window wiper motor nuts.
-
To install, tighten to 7 Nm (62 lb-in).
3. Remove the rear window wiper motor.
7. To install, reverse the removal procedure.