Escape 2WD L4-2.5L Hybrid (2010)
Compass: Adjustments
Compass Calibration
Compass Calibration
NOTE: This procedure is only applicable to vehicles without navigation. For vehicles with navigation, there is no compass calibration.
1. NOTE: For optimum calibration, drive to an open, level location away from large metallic objects or structures such as bridges, steel buildings,
etc. Switch off all non-essential electrical accessories (heated rear window, heater fan, A/C, map lamps, and wipers) and make sure all doors are
closed.
Start the vehicle.
2. NOTE: The vehicle remains in the CAL mode until the compass has been successfully calibrated.
NOTE: While holding the Front Controls Interface Module (FCIM) 7 and 9 buttons down, the compass display first enters the ZONE setting
mode (after 5 seconds) and then after another 5 seconds (approximately 10 seconds total), the compass display enters the CAL mode.
Press and hold (for approximately 10 seconds) the FCIM 7 and 9 buttons until the CAL indicator appears in the display, then release the buttons.
3. NOTE: If the CAL indicator does not turn off after the vehicle is driven in a circle at least 5 times, repeat the procedure.
Drive the vehicle slowly at less than 5 km/h (3 mph) in a continuous circle until the CAL indicator disappears from the display and the compass
heading is shown.
4. If the CAL message does not turn off after driving in a circle at least 5 times (and the procedure has been repeated at least once), install a new
compass module (integral to the interior rear view mirror). For additional information, refer to Interior Rear View Mirror in Mirrors.