Escape 2WD V6-182 3.0L VIN 1 SFI (2002)
14. Disconnect the battery ground cable and wait at least one minute.
15. Position the carpet back at the right-hand side of the center tunnel area under the instrument panel.
16. Remove the right-hand side restraint control module (RCM) retaining bolts.
17. Remove the lower LH center instrument panel finish panel.
18. Position the carpet back at the left-hand side of the center tunnel area under the instrument panel.
19. Remove the RCM.
1
Slide and disengage the two RCM electrical connector locking dips.
2
Push down to pivot the RCM electrical connector tabs and pull out to disconnect.
3
Remove the retaining bolt.
4
Remove the RCM.