Escape 2WD V6-3.0L (2009)
Sound Proofing / Insulation: Description and Operation
Sound Deadeners and Insulators
SOUND DEADENERS AND INSULATORS
WARNING: Always refer to Material Safety Data Sheet (MSDS) when handling chemicals and wear protective equipment as directed.
Examples may include but are not limited to respirators and chemically resistant gloves. Failure to follow these instructions may result in
serious personal injury.
NOTICE:
-
Mastic is made of a combustible material and should be removed prior to carrying out welding procedures to the area. Heat zones from
welding near the mastic can cause the mastic material to burn.
-
Corrosion protection must be restored to the area AFTER the mastic material is applied. Corrosion protection products may be wax
based and loss of adhesion may occur.
NOTE:
-
To restore the vehicle to design intent, missing or damaged sound deadeners and insulators should be installed with the correct service replacement
component.
-
The following illustrations serve as a reference to indicate mastic patch (butyl pad) locations. Additional insulators and sound deadeners are used
beyond those indicated in the illustration.
Sound Deadeners and Insulators
Floor Pan Sound Deadeners
NOTE: To restore the vehicle to design intent, missing or damaged sound deadeners and insulators should be installed with the correct service
replacement component. Sound deadeners in this illustration all use base part number 99P30A3.
