Escape 2WD V6-3.0L (2009)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Ring - Rear
Wheel Speed Sensor Ring - Rear
Removal and Installation
Front Wheel Drive (FWD) vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the rear wheel hub nut.
-
To install, tighten to 290 Nm (214 lb-ft).
3. Remove the sensor ring from the wheel hub.
4. To install, reverse the removal procedure.
All-Wheel Drive (AWD) vehicles
5. The rear wheel speed sensor ring is integral to the rear axle halfshaft and cannot be repaired separately.