Escape 2WD V6-3.0L (2009)
2. Remove the Hydraulic Control Unit (HCU) See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Hydraulic Control
Assembly - Antilock Brakes/Service and Repair. For additional information, refer to Hydraulic Control Unit (HCU) See: Brakes and Traction
Control/Antilock Brakes / Traction Control Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair.
3. Remove the jumper tube assembly bracket nut.
-
To install, tighten to 9 Nm (80 lb-in).
4. Disconnect the jumper tubes fittings from the HCU and remove the jumper tube assembly.
-
To install, tighten to 15 Nm (133 lb-in).
All vehicles
5. Remove the 4 ABS module screws and the ABS module.
-
To install, tighten to 2 Nm (18 lb-in).
6. To install, reverse the removal procedure.
7. Configure the ABS module.
8. Calibrate the ABS module.
-
For non-hybrid vehicles, carry out the IVD Initialization sequence following the scan tool directions.
-
For hybrid vehicles, carry out the Multi-Calibration routine following the scan tool directions.
