Escape 2WD V6-3.0L (2009)
instructions may result in component damage and/or system failure.
NOTE: During passenger air bag module installation, make sure all the passenger air bag cover clips are fully seated into the instrument panel.
Through the glove compartment opening, release the passenger air bag module passenger air bag cover clips while pushing the passenger air bag
module out of the instrument panel.
4. Remove the passenger air bag module.
1. Disconnect the 2 passenger air bag module electrical connectors.
2. Detach the wire harness routing clip and remove the passenger air bag module.
5. NOTICE: During installation, make sure the passenger air bag module wire harness routing clip is attached to the passenger air bag
module. Failure to follow this instruction may result in wiring harness damage.
To install, reverse the removal procedure.
6. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures.
