Escape 2WD V6-3.0L VIN 1 (2004)
Brake Bleeding: Service and Repair
Brake System Pressure Bleeding
Brake System Pressure Bleeding
Special Tool(s)
WARNING: Use of any other than the approved DOT 3 brake fluid will cause permanent damage to brake components and will render the
brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled
with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
NOTE: When any part of the hydraulic system has been disconnected for repair or replacement, air may enter the system, causing spongy brake pedal
action. This requires the bleeding of the hydraulic system after it has been correctly connected.
1. Clean the outside of the brake master cylinder reservoir.
2. Remove the reservoir cap and fill the brake master cylinder reservoir with brake fluid.
^
Use High Performance DOT 3 Brake Fluid C6AZ-19542-AB or equivalent meeting Ford specification ESA-M6C25-A, DOT 3.
3. NOTE: Master cylinder pressure bleeder adapter tools are available from various manufacturers of pressure bleeding equipment.
Follow the instructions of the manufacturer when installing the adapter.
Install Brake Bleeder to the brake master cylinder reservoir, and attach the Brake Bleeder tank hose to the fitting on the adapter.
