Escape 4WD L4-2.3L VIN H Hybrid (2005)
2. NOTE: Clean and inspect the gasket. Install a new gasket, if necessary.
Install the valve cover, gasket and retainers.
^
Tighten in the sequence shown to 10 Nm (89 inch lbs.).
3. Connect the CHT sensor electrical connector.
4. Connect the fuel rail pressure and temperature sensor electrical connector.
5. Connect the CMP sensor electrical connector.
6. Install the 3 engine cover studs.
7. Connect the crankcase vent hose.
8. Install the ignition coil-on-plugs.