Escape 4WD L4-2.3L VIN H Hybrid (2005)
Drive/Propeller Shaft: Service and Repair
Driveshaft Runout and Balancing
Driveshaft Runout and Balancing
Special Tool(s)
1. Remove the rear tires.
^
Install the lug nuts to retain the brake drums or brake disc.
2. Check the rear driveshaft attachment. If there are any worn parts, new parts need to be installed.
3. Using the special tool, measure the runout at the front, the center, and the rear of the driveshaft.
4. If the runout measurements are within specifications, go to Step 13.
5. If the runout measurements exceed the specifications at the front or the center, then install a new driveshaft.
6. If the runout measurement exceeds the specifications at the rear, mark the rear runout high point on the driveshaft.
7. Scribe alignment marks on the driveshaft and the axle pinion flange.
8. Index the driveshaft.
9. Using the special tool, measure the runout at the rear of the driveshaft.