ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2738 > < Initial Inspection and Diagnostic Overview|Page 2736
Page 60
background image

Yes

GO to T15. 

No

CONNECT the negative battery cable. GO to T38.

-------------------------------------------------
T15 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE OCSM DISCONNECTED

-

Disconnect: OCSM C3285 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with an Accessory Protocol Interface Module (APIM), GO to T16. 

If the vehicle is not equipped with an APIM, GO to T17. 

No

CONNECT the negative battery cable. GO to T39.

-------------------------------------------------
T16 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE APIM DISCONNECTED

-

Disconnect: APIM C3338 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to T17. 

No

CONNECT the negative battery cable. GO to T40.

-------------------------------------------------
T17 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE IC DISCONNECTED

-

Disconnect: IC C220 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

Initial Inspection and Diagnostic Overview|Page 2738 > < Initial Inspection and Diagnostic Overview|Page 2736