Escape 4WD L4-2.5L Hybrid (2009)
Seat Cover: Service and Repair
Rear Seat Backrest Cover
Seat Backrest Cover - Rear
NOTE: For component identification and locations, refer to Seat - Exploded View, Rear See: Service and Repair/Rear Seat - Exploded View.
1. Remove the rear seat backrest. For additional information, refer to Seat Backrest - Rear See: Seat Back/Service and Repair/Removal and
Replacement/Rear Seat Backrest.
2. Remove the head restraint(s).
3. Remove the 2 screws and latch cover.
4. Remove the 2 seat latch release handle screws.
5. Remove the seat latch release handle.
1. Detach the latch rod from the seat latch release handle.
-
To aid installation, lock the latch using a flat-blade screwdriver before connecting the latch rod.
2. Remove the seat latch release handle.
6. Release the backrest cover J-clip.
7. Unzip the backrest trim cover zipper.
8. NOTE: The inboard and outboard head restraint guides are not interchangeable.
Squeeze together the tip of each head restraint guide and remove from the backrest frame.
-
Note the alignment tab position for correct installation.
