Escape 4WD L4-2.5L Hybrid (2009)
1. For additional information, refer to the procedures.
Brake Caliper Anchor Plate
Brake Caliper Anchor Plate
Removal and Installation
1. NOTE: The following steps must be followed to prevent the accumulator from charging and pressurizing the brake system.
Disconnect the battery.
2. Remove the Battery Junction Box (BJB) fuses 9 (50A) and 18 (50A).
3. Remove the wheel and tire.
4. NOTICE: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.
Remove the 2 brake caliper guide pin bolts and position the caliper aside.
-
Support the caliper using mechanic's wire.
5. Remove the 2 brake caliper anchor plate bolts.
-
To install, tighten to 175 Nm (129 lb-ft).
6. Remove the brake caliper anchor plate.
7. To install, reverse the removal procedure.
