Escape 4WD L4-2.5L Hybrid (2009)
5. NOTE: The lower RH center panel duct screw is located just below the RH lower rear corner of the Audio Control Module (ACM).
Remove the lower RH center panel duct screw.
1. Detach the wire harness pin-type retainer.
2. Remove the lower RH center panel duct screw.
6. Working through the glove compartment opening, detach the wire harness pin-type retainer above the evaporator discharge air temperature sensor.
7. Disconnect the RH temperature blend door actuator electrical connector.
8. NOTICE: Use care to avoid dropping the RH temperature blend door actuator screws into the plenum chamber when removing the
screws. If a screw is dropped into the plenum chamber, it may cause the airflow mode doors to jam, or may cause noise concerns.
NOTE: The RH center instrument panel duct must be slightly repositioned to allow access to the RH temperature blend door actuator screws.
Remove the 2 RH temperature blend door actuator screws.
-
To install, tighten to 3 Nm (27 lb-in).
9. Remove the RH temperature blend door actuator.
10. To install, reverse the removal procedure.
Temperature Blend Door Actuator - LH
Temperature Blend Door Actuator - LH
