Escape 4WD L4-2.5L Hybrid (2009)
Removal and Installation
NOTE: Installation of a new receiver/drier is not required when repairing the A/C system, except when there is physical evidence of contamination from
a failed A/C compressor or damage to the receiver/drier.
1. Recover the refrigerant.
2. Remove the DC/DC converter. For additional information, refer to Hybrid Drive Systems.
3. Remove the front bumper cover.
4. Remove the compressor manifold and tube bracket nut.
-
To install, tighten to 8 Nm (71 lb-in).
5. Remove the condenser outlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal.
6. Remove the evaporator outlet line fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
7. Remove the auxiliary evaporator outlet line fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seals.