Escape 4WD L4-2.5L Hybrid (2009)
harness side.
-
Measure the resistance between the FDIM C2123-5, circuit VDB07 (VT/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG),
harness side.
-
Are the resistances less than 5 ohms?
Yes
CONNECT the negative battery cable. GO to N4.
No
REPAIR the circuit in question. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
N4 CHECK FOR CORRECT FDIM OPERATION
-
Disconnect the FDIM connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the FDIM connector and make sure it seats correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new FDIM. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the
network test with the scan tool.
-------------------------------------------------
Pinpoint Test O: The Front Controls Interface Module (FCIM) Does Not Respond To The Scan Tool
Communications Network
Pinpoint Tests
Pinpoint Test O: The Front Controls Interface Module (FCIM) Does Not Respond To The Scan Tool
Refer to Wiring Diagram Set 14 (Escape/Mariner, Escape Hybrid/Mariner Hybrid), Module Communications Network for schematic and connector
information. See: Diagrams/Electrical Diagrams/Diagrams By Number
